Firmware Intel 320 Series SSD

Matériels

Autre mises à jour

• [17/08/2011] 1.9

Version

1.9

Information concernant la mise à jour

Mise à jour du 17/08/2011
- Type: Firmware
- Langue: Anglais

Télécharger la mise à jour 4,3 Mo

Description

Intel 320 Series Solid State Drive SSD disque mise à jour firmware version 1.9

Descriptif mise à jour :
- Mise à jour du firmware des SSD Solid State Drive 320 Series en version 4PC10362 afin de corriger l'erreur BAD_CTX 13x Error et le problème de détection de la capacité du SSD à seulement 8 Mo qui se produisent suite à une coupure de courant ou à un arrêt incorrect de l'ordinateur.

INSTRUCTIONS ON UPDATING FIRMWARE

See the Firmware Update Tool Guidelines for complete instructions.

1. Load the .ISO image onto a blank CD (CD-R or CD-RW) using 
    CD-ROM burning software of your choice.

2. Ensure the Intel SSD is attached to a SATA port in the system. 
    For best results, ensure the SATA port is a native control
    port of your south bridge controller (generally
    SATA ports 0 through 4).  SATA ports attached to a third-party
    SATA controller bridge chip or add-in SATA controller
    expansion cards are not recommended for use when updating
    the firmware. For more details, consult your system technical
    documentation.

3. Insert the Intel SATA SSD Firmware Update CD into the system.

4. Ensure the CD-ROM drive is enabled as a bootable device in BIOS
    and the CD-ROM boot priority is ahead of the drive containing
    the OS boot partition.  For more details, consult your
    system documentation.

5. Complete a safe system shutdown and power off completely, count to
    10 (seconds), and then reboot the system. A restart or warm reset
    (CTRL-ALT-DEL) is not adequate.

6. Power on your system to start the update process.

- The tool will prompt you through the update process
    for all the SSDs that qualify for the firmware update
    in your system.

- To verify that the firmware update is complete, power down per step 5
    above with the CD still installed and let the
    firmware update software scan for SSDs in your system
    again. The scan should now display your SSD and the
    firmware should now show the new firmware number for your
        specific SSD.

- Once the firmware has been verified, remove the CD and
    power down the system again.

- If you changed SATA port mode from AHCI to "Compatibility" or
    or "Legacy" mode for the firmware update, ensure you
    change the port back to AHCI mode for best performance.

Note: For computers booting into Windows 7 after a firmware update,
a message appears when the operating system starts that prompts
you to restart the computer. Restart when prompted.

Retour page constructeur